Assisted Roll Systems
Elliott's assisted rolling family — Table Hawk, Rapid Hawk (electric and hybrid), and Monster Hawk — takes the physical strain out of high-volume tube rolling. Table Hawk handles small tubes at the bench; Rapid Hawk's articulated arm cuts operator fatigue; Monster Hawk's servo motor adds parallel-pin expansion at speed. Combined range: 0.25" – 3.00" OD.
الفئة
Rolling Motors & Assisted Systems
التوفر
متوفر
لمحة سريعة
- Combined tube size
- 0.25" – 3.00" OD (6.35–76.2mm)
- Table Hawk
- ~1/4"–5/8" OD tabletop unit
- Rapid Hawk
- Pneumatic/electronic hybrid, articulated arm
- Monster Hawk
- Electric servo motor, parallel-pin capable
استفسر عن هذا المنتج
تواصل معنا للحصول على الأسعار والتوفر
Assisted Roll Systems
Elliott's assisted rolling family — Table Hawk, Rapid Hawk (electric and hybrid), and Monster Hawk — takes the physical strain out of high-volume tube rolling. Table Hawk handles small tubes at the bench; Rapid Hawk's articulated arm cuts operator fatigue; Monster Hawk's servo motor adds parallel-pin expansion at speed. Combined range: 0.25" – 3.00" OD.
الفئة
Rolling Motors & Assisted Systems
التوفر
متوفر
لمحة سريعة
- Combined tube size
- 0.25" – 3.00" OD (6.35–76.2mm)
- Table Hawk
- ~1/4"–5/8" OD tabletop unit
- Rapid Hawk
- Pneumatic/electronic hybrid, articulated arm
- Monster Hawk
- Electric servo motor, parallel-pin capable
استفسر عن هذا المنتج
تواصل معنا للحصول على الأسعار والتوفر
المزيد من ELLIOTT TECHNOLOGY TOOLS
منتجات ذات صلة
Right Angle Pneumatic Roll Motors
The 445 Series turns its drive head 90 degrees off-axis so it can roll boiler tubes in tight, hard-to-reach locations a straight motor can't access. Available in torque-controlled and stall-type versions with roll or lever throttle, it runs on 90 PSI shop air. Tube size range: 2.000" – 4.000" OD.
عرض التفاصيل
ET850 Torque Controlled Pneumatic Rolling Motor
The ET850 is Elliott's next-generation push-pull rolling motor, using pneumatic torque control to stop expansion at a precise, repeatable target and guard against over-rolling in boiler and heat exchanger tubes. Tube size range: 0.750" – 1.250" OD.
عرض التفاصيل
ET720 Torque Controlled Pneumatic Rolling Motor
Scaled down for the small-bore tubes common in oil coolers and compact heat exchangers, the ET720 brings the same pneumatic torque control as its larger ET850 sibling to a 0.250" – 0.375" OD range, protecting delicate tubes from over-expansion.
عرض التفاصيل